How To Install Floor T Moulding?

When laying floors, transition strips are often needed to ensure a perfect transition of edges or a delicate surface finish. PVC floor T mouldings are the most commonly used accessories for floor laying.

So, how is this floor transition strip installed? This article will provide a detailed introduction.

Tool Preparation

• Tape measure

• Pencil

• Hand saw or metal cutter

• Sandpaper

• Structural adhesive

• Screws

• Power drill

• Rubber hammer

• Rag

• Safety goggles

• Gloves

Installation steps

1. Use a tape measure to accurately measure the required length of the floor T-moulding in the installation area and keep a record.

2. Then use a tape measure to measure the corresponding length on the floor T-moulding and mark it with a pencil.

3. Use a hand saw or metal cutter to cut the floor T-moulding and sand the edges to ensure there are no burrs.

4. Place the base in the gap between the two floorboards and press the floorboards against the wider side of the base. Then use an electric drill to drill holes along the base groove and fix it with screws.

5. Pour structural glue into the base groove and embed the floor T-moulding into the base. Tap gently with a rubber hammer and tighten.

6. Clean the profile with a rag to ensure there is no debris or impurities left on the surface.

Other T-type floor transition strips

CREATEKING is a professional manufacturer of PVC floor decoration profiles. We provide high-quality and durable PVC floor T-shaped lines. If you are interested in learning more, please feel free to consult us!